Eşyalarını Tamir Et Topluluk Mağaza

Repair guides for Android smart phones manufactured by Wiko.

40 Soru Tümünü görüntüle

Seçenekler

Stuck at FRP after factory reset and firmware system update

Wiko View Go

Model: W_P130

M_IMEI 357483090076511

S_IMEI number 357483090147130

History:

  1. upon power-on, phone stuck in boot loop.
  2. Factory reset performed
  3. Stuck at FRP with correct credentials for pattern and Google account
  4. System firmware update installed via pc <W_P130-V01.30.OPE-[Orea-8.1]-GBL>
  5. Stuck again at FRP with correct credentials for pattern and Google account

Should I send it to Wiko Repair Service? It was bought in Germay.

Any help and advice will be appreciated.

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski

Seçenekler

Thank you for the suggestion. However, if you read through my question you will see that I did all this without success.

And now I cannot even get into recovery mode, (by pressing vol. up and power), although I did this many times before the system update. Anyway, I don’t think I can use recovery mode for any solution to the problem.

Is there any possibility that the original problen <stuck in boot loop> could have been caused by a hardware malfunction? Maybe the phone got dropped or sat on.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0
Yorum Ekle

Yanıtını ekle

Cheryl Carling sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 7

Her zaman: 249