Eşyalarını Tamir Et Topluluk Mağaza

BlackBerry Key2 (BlackBerry KEY² olarak stilize edilmiştir), dikey yönelimli, sabit (kaymaz) tümleşik donanım klavyesine sahip dokunmatik ekran tabanlı bir Android akıllı telefondur. Key2 LE, TCL Corporation tarafından BlackBerry Mobile markası altında üretilir ve 3 renkte sunulur. BBF100-1 (AB, Afrika, AU) modellerini içerir; BBF100-2 (Kanada, ABD, LATAM); BBF100-6 (ME, APAC, Hindistan); BBF100-4 (Çin).

5 Soru Tümünü görüntüle

Seçenekler

How do I fix an antenna broken off the mainboard?

Hi

During a screen replacement, the “male” part of this blue cable (i think it’s the antenna) did break off the mainboard (slot 2) and is is now “stuck” inside the cable.

How can I replace the “male” part on the mainboard? Do I have to solder? Because I’m not that experienced in solder tiny things so I’m kind of afraid to break even more.

The local smartphone doctor would charge me $70 for a repair - is that a fair price or way too much?

Kind Regards

Cedric

Block Image

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 1
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

You can do a right repair: Find the broken piece and solder it back, or Order a new piece and solder it back, or take the piece from a donor board and solder it back.

You can do a quick repair: Remove the head from the cable, solder the outside cable to ground and the internal cable to the signal pad.

Is a five minutes task, but you need to have the equipment and the knowledge to complete the task. From $30 to $50 I think it’s OK

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 2

4 Yorum:

I think this is horrible advice. “You need the right equipment…”. Yes! This is a microsoldering job, and if you muck it up, the motherboard is toast. I paid $150 to fix mine, at Microsoldering.com. This failure apparently happens often.

tarafından

Agreed. I have soldered these u.fl connections. They are very small, difficult to solder. And easy to cause a short circuit.

tarafından

@Bob Haberkost $150?????????? Jesus, I’ve soldered these on for £5 😂 Some places really take the mick.

tarafından

guys, soldering antennas is stupid! I think I've already fed a few things in my 44-year-old life. this doesn't work - I fried the parts around in a few seconds - key2 written off - second attempt a couple of months later - conductive glue, then pour it hard in epoxy - the only option! all key2 have a huge defect in the quality of the male connector - before you start anything, it's better to stick it hard on the MB - it will save a lot of problems and worries

tarafından

Yorum Ekle

Yanıtını ekle

Cedric sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 gün: 4

Son 30 gün: 13

Her zaman: 1,294