Eşyalarını Tamir Et Topluluk Mağaza

High-end multimedia laptop by Asus.

9 Soru Tümünü görüntüle

Seçenekler

cpu block screw nut disconnected from N551W motherboard

My laptop had an accident lately and its CPU start to heat up so fast so I opened it and saw that two of CPU block nuts disconnected from motherboard. I resolderd them but they disconnected again. I tried to resolder them for 4 or 5 times but again they disconnect so quickly. How can I make them to stay in their places and not to fall out? Is there any special adhesive use for this purposed?

Block Image

both shown nuts are disconnected, blue one was resolderd when I took the photo but disconnect in les than half an hour

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 1
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

It’s a bit fiddly, but finding the right size screw/nut&bold is better than any glue. You want to give it something to latch onto from the under side. This is that way I normally do it for long term results when the proprietary fitting is beyond repair. The issue your going to have with glue is both pressure and heat.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1

1 Yorum:

I was thinking about adding longer screw and nut at the back of pcb but i have some serious issues founding some right size nuts. My laptop has fan problem too ( magnetic levitation not working) and i couldn't find any replacement for it and I can't import because it will cost so much and I afraid this will happen again for nuts.

I should look at electronic dumpster.

Thanks for the answer

Best regards

tarafından

Yorum Ekle

Yanıtını ekle

Matin sadroddin sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 2

Son 30 gün: 4

Her zaman: 132