Ana içeriğe geç

22 Eylül 2017'de satışa sunuldu. Model A1863, A1905 olarak tanımlanıyor. GSM ya da CDMA olarak 64 ya da 256 GB kapasitelerinde, Altın, Gümüş, ve Uzay Grisi renklerinde satılır.

873 Soru Tümünü görüntüle

Random colored lines after reconnecting screen to logic board

Block Image

Block Image

So I don't know what I did but those lines appeared when I reconnected the screen and lcd cables again. the screen is not cracked or the LCD I think I broke something idk what but that screen worked just fine before I did that I really need help on this

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
Seçilen Çözüm

It could be that the connectors are not fully connected into place. Double check all the display connectors to make sure that it is connected properly. If it still has lines on the display, inspect the cables to the screen as well as the connection points on the board to make sure nothing is torn or damaged.

Bu yanıt yardımcı oldu mu?

Puan 1

3 Yorum:

Ok so I have disconnected a lot of times the screen before this happened I checked and nothing appears to be damage but I know that while I was opening it I tore a little bit the top ribbon cable were the ear piece speaker is do you think that is the problem

tarafından

@alexiolabest It sounds like the display cable has been torn, even slightly can cause that problem. You are probably going to need a new display, as I do not think that you can repair that.

tarafından

@carsman248 thanks for the advice I thought that the top ribbon cable was for the sensor and I didn't have any affect because the two bottom cables look in mint condition so I guess I gotta buy a new screen and a battery

tarafından

Yorum Ekle

Yanıtını ekle

Alexis perez sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 48