Eşyalarını Tamir Et Topluluk Mağaza

Charging station for the Dualsense PS5 controller.

3 Soru Tümünü görüntüle

Seçenekler

Dualsense Charging Station Tear Down Guide

One of the charging ports on my charging station is no longer working. I think one of the metal contacts that is supposed to spring up is trapped in the plastic housing. Does anyone know how to open this thing so I can try and re-seat it?

Thanks!

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 6
2 Yorum

I have the same issue too...

Can you make a teardown video in order to get to the broken metal contact

tarafından

Does anyone know where to get replacement spring connectors or prongs?

tarafından

Yorum Ekle

2 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler
  1. Take DualSense charger and front facing you, turn over so the bottom is up. Locate seam where plastic meets plastic and use wedge to open and pop the plastic internal clips.

Block Image

  1. Slowly lifting and working your way back, pull up and release clips to remove bottom piece.
  2. Remove four screws that hold the base to the charging ports and separate.

Block Image

Block Image

  1. If you want to further remove the side plates, remove the two screws located in the following two locations.

Block Image

Block Image

  1. Once all four are removed, slowly pull back on side panels to release the plastic clips that hold on side panels.
  2. Basic teardown complete!

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 6
Yorum Ekle

Seçenekler

I got one of these that was thrown out at my local gamestop because they said it wasnt charging. I had the same problem where one of the pins was not being exposed when the plastic part moves down. I just used a box cutter knife and used the edge to bend the flattened pin upwards so that it was poking out again. Dont bend them too much because i think they need to make contact with the metal underneath the plastic but just enough to get them poking up again.

You could probably use a tweezers or other small metal instrument to do this as well.

I didnt need to disassemble. It seems like its easy to fold them under the plastic housing that the controller pushes down to expose the connectors.

Unplug the unit before doing this, to be safe.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1
Yorum Ekle

Yanıtını ekle

TT_El_Barto sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 5

Son 7 gün: 49

Son 30 gün: 204

Her zaman: 4,955