Eşyalarını Tamir Et Topluluk Mağaza

Released September 21, 2018. Models A1920, A2097, A2098, A2100. Available as GSM or CDMA / eSIM or nano-SIM / 64, 256, or 512 GB / Silver, Gold, or Space Gray. (Pronounced "iPhone 10 S.")

401 Soru Tümünü görüntüle

Seçenekler

Attempting to restore always fails (error 4013)

I disconnected every single sensor, only left battery and dock (USB) port sensors connected.

My device by default already always goes into "Recovery Mode". From there using iTunes or 3UTools, as soon as I select a firmware or backup and click on "Restore" system boots into "installing update/firmware mode", I see the spinning wheel for 2-3 seconds and then system boots back again into Recovery Mode and obviously no update gets installed and nothing works. What am I missing?

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
Seçilen Çözüm

Seçenekler

This is most likely a hardware fault. The CPU cannot communicate with the NAND it could be a faulty CPU or faulty NAND most likely the latter. The repair would be expensive and only viable if the data needed to be recovered.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1

1 Yorum:

@itestandroid yeah that's rough Chris is likely right. Your NAND chips have likely got some kind of false data that has corrupted it all.

Did this just randomly happen or did something (EG a surge in voltage or an overnight update) lead to this. I have an Apple watch S4 that had software corruption but a secret trick has brought it back to life.

tarafından

Yorum Ekle

Yanıtını ekle

iTest sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 2

Son 30 gün: 6

Her zaman: 328