Ana içeriğe geç

Repair guides and disassembly information for Apple's 7th generation iPad. Released September 25, 2019. Model numbers: A2197, A2200, and A2198.

72 Soru Tümünü görüntüle

Pulled pads on board for charging port

I was trying to replace the power connector on my iPad 7 and I pulled some pads will need to use some jumper wires. Does anyone have a pin out diagram for this connector?

Update (04/11/2022)

Thanks

Block Image

Block Image

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 1

Yorumlar:

add a photo of the missing pads, might be no connect or ground

tarafından

Yorum Ekle

1 Cevap

Filtre ölçütü:
En Yararlı Yanıt

It's a little hard to make out from your pictures which pads specifically are pulled. But I think really there's only one I can absolutely identify that you need to worry about.

I forgot to actually write what's what in the pic. But really it doesn't matter all that much aside from noting that anything connected together/the same color is redundant and likely doesn't need to be replaced. The orange one is the only one I would be concerned about since it definitely looks pulled and no other pin on that line. You should be able to just scratch up some of the trace there that's coming off the pad for a jumper. If not, there's a test point on that line as well which I colored orange to run a jumper to.

Also put the schematic here for this connector just for reference. I can revise for any other pads you're having issues with if i missed something.

Block Image

Block Image

Bu yanıt yardımcı oldu mu?

Puan 3
Yorum Ekle

Yanıtını ekle

Terry sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 1

Son 30 gün: 22

Her zaman: 115