My Ryobi sander started making a strange noise and is not sanding proper. I made sure there were no loose screws, cleaned it and then let it sit for a few hours to cool down as I had been sanding on and off for several hours. Unfortunately none of these seemed to help. What could be causing this and is it fixable ?
Bu iyi bir soru mu?
İtibar: 551
9
8
13
Possibly a bearing going, either to or bottom. I’d split it in two and remove the motor and check them. Could be wear on the base where the bearing sits.
Bu yanıt yardımcı oldu mu?
Son 24 Saat: 0
Son 7 gün: 10
Son 30 gün: 32
Her zaman: 300
2 Yorum
What sander is it? Belt, orbital, detail sander?
[deleted] tarafından
It is a Ryobi corded orbital sander
bhowse@live.ca tarafından