Eşyalarını Tamir Et Topluluk Mağaza

Model Number A1707. Released June 2017, this MacBook Pro features Kaby Lake processors up to the 2.8 GHz quad-core Intel Core i7 processor with Turbo Boost up to 3.8 GHz.

327 Soru Tümünü görüntüle

Seçenekler

Trackpad is clicking but the trackpad moves by itself!

Recently I bought a MacBook Pro 2017 A1707 trackpad is clicking but it doesn't track when you move your finger.

It moves by itself and sometimes opens the Lunchpad which is wired. I replaced the trackpad but it was the same then I changed the top case it didn't change anything.

Update (08/22/23)

Block Image

I checked them already, It has 12.60 V. I'wondering how it moves by itself.

Update (08/22/23)

Block Image

I found the pin 41 it is broken but it is ground. what can I do??

Update (08/22/23)

Block Image

It is ACT GND

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
1 Yorum

@armin1 anytime you have a disconnected pin etc.it is advisable that you repair this. Even GND is needed to function and missing ground can give weird results. I suggest you fix that connection and re-evaluate

tarafından

Yorum Ekle

2 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

If you replaced the trackpad and the top case and the trackpad cable and you're still unable to use the trackpad properly then there is probably a larger issue with the main logic board or software. Have you tried reinstalling your OS? If the issue persists on a device with a new top case, trackpad, trackpad cable, and clean OS installation then the problem is almost definitely due to a fault on the main logic board. Good luck!

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1

4 Yorum:

"I wanted to reinstall the OS, but when I press the option key to choose a drive or flash drive, the trackpad is still experiencing the same issue. Do you think it will be okay if I proceed with the installation process??"

tarafından

I installed a fresh macOS, but it has the same problem.

tarafından

which part of the board needs to be checked?

tarafından

I'm not sure where the issue would likely be. I'd recommend removing the logic board carefully and then fully inspecting it for any signs of damage. Also, when you replaced the top case did you replace the battery as well?

tarafından

Yorum Ekle

Seçenekler

@zpl @armin1 here is the Trackpad connector diagram Check those pins on your board. Interesting to see that the trackpad has its own fuse. See if you have the required 12.6V on that. F4500 is just above the connector L4500 and C4500 are on the opposite side. Pin 1 of the connector is the one on the bottom left of your logic board.

Block Image

This is not as to interfere with the troubleshooting by @zpl but just to augment it.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1

1 Yorum:

Nice! Thanks!

tarafından

Yorum Ekle

Yanıtını ekle

Armin sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 2

Her zaman: 55