Eşyalarını Tamir Et Topluluk Mağaza

Model A1419 / EMC 3070 / Mid 2017 / 3.4, 3.5 or 3.8 GHz Core i5 or 4.2 GHz Core i7 Kaby Lake Processor (ID iMac18,3) / Retina 5K display. Refer to the older iMac Intel 27" Retina 5K Display (Late 2014 & 2015) guides as the system is very similar.

293 Soru Tümünü görüntüle

Seçenekler

Black screen after hard drive replacement

Hi,

I replaced the HHD to an SDD following the instructions on ifixit. Before gluing the screen with new stripes, I tested the devices by turning it on. Everything worked and I was able to re-install the macOS. So far so good.

Next, I used the stripes to finalize the process. It seems, that something got wrong during that step: my screen is black now.

So, I re-opened the iMac again and checked, whether I forgot to connect a cable or damaged anything in course of the process. Didn‘t find any hints, though.

Next, I connected the two cables, put the display back (w/o the stripes) and started the device. I am able to see some content on the screen, but it‘s very dark.

=> My assumption is, that the backlight is not working. Maybe I damaged the cable or even more. Would you agree?

I would like to start with replacing the cable. Question: which one (of the two)?

Thanks in advance.

Update (02/03/24)

Block Image

Block Image

Block Image

Block Image

Block Image

Block Image

Block Image

Block Image

Block Image

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

Referencing this guide iMac 27" 2017 Display Replacement

Jump to Step 19 this cable is the power cable and Step 20 is the data cable.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1

5 Yorum:

Hi,

Apology for the rather late reply.

Thank you for this hint. This is helpful.

Would the recommendation be to rather trying to replace the power cable first?

Thanks in advance!

tarafından

@eugen59161 - Let’s get a good set of images of your power cables logic board connector to make sure it’s OK first as well as the cable connector end as well.

tarafından

@danj, certainly.

I updated the question and added the images.

Btw: I reconnected everything once again - unfortunately no improvement

MANY thanks in advance!!!

tarafından

@eugen59161 - Well the cables and connectors look good! So that’s not the issue. That only leaves one possibility, could you have flipped the displaces data cable plugging it in backwards? While the backlight and logic uses the the power cable there are a few lines that can get damaged within the data cable if you reverse the cable plugging it in the wrong way and then powering the system.

tarafından

Hm, that‘s a very good question. To be very certain with my answer, I actually opened and closed the display again. While doing so, I noticed that there is almost no chance I connected incorrectly. I.e, I am 99,9% certain that I connected correctly.

tarafından

Yorum Ekle

Yanıtını ekle

Eugen sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 3

Son 30 gün: 5

Her zaman: 46