I know how to solder and would like to remove the port completely and just have the powerblock permanently attached, I don't know how to tell whats positive, negative, neutral. Any help would be appreciated
Bu iyi bir soru mu?
İtibar: 1,5b
10
1
2
You need to use a multimeter, to check voltage and to check resistance (ohms). Even a cheap multimeter from amazon will work.
The center of the plug that goes into the laptop is usually positive. +20 volts dc. The outside ring is then ground, 0 volts.
If you are soldering inside the laptop you have to solder the + wire to where the tip/center metal connects. Use the ohms setting of the multimeter the tip to wire resistence to confirm where the + wire is soldered.
But there is risk of course. If you're not careful inside you could damage the laptop.
Bu yanıt yardımcı oldu mu?
Son 24 Saat: 0
Son 7 gün: 0
Son 30 gün: 2
Her zaman: 9
