ÇÖZÜLDÜ: Dualshock 4 potentiometer soldering mistake - DualShock 4 CHU-ZCT2U

Dualshock 4 potentiometer soldering mistake

Hi, I.made a mistake desoldering one of the pins of a potentiometer trying to replace it and I think that I peeled the contact, ruining the trace. My question is, attending to the photos, If I scratch de blue marked area, can I steel discover part of the trace and try to solder it? Or how can I find out the way of following the trace to scratch a little bit and uncover it to fix it making a bridge using a little bit of copper cable? Thanks!

Gönderildi: 28 May 2025

Seçenekler

Hi!

It is damaged, but it's possible that it can still make contact. It's not completely ruined or broken, just a part of it. So you can try to solder it on and see how it goes.

When you do need to repair the trace, this can be tricky.

You can find some info here: How To Repair Damaged / Broken PCB Traces - 2 Great Methods

It won't be easy, but worth the try!

Bu yanıt yardımcı oldu mu?

Evet Hayır

Puan 1

4 Yorum:

Thanks for your answer! The point is that I can not see where the trace is going, I have to scrach the green cover of the blue mark in the photo to uncover part of the trace?

verjav tarafından 28 May 2025

Probably yes. I can't see any trace there at all, for the other points I do see them. I would just solder the new one in and see how that goes. If it fails, then you need to scratch it away so it may reveal the trace.

koppie007 tarafından 28 May 2025

Ok, I will try. Thanks a lot @koppie007 !!

verjav tarafından 28 May 2025

My pleasure! Good luck with the repair!!

koppie007 tarafından 28 May 2025

Yorum Ekle

DualShock 4 CUH-ZCT2

Dualshock 4 potentiometer soldering mistake

1 Cevap

Yanıtını ekle