Giriş

This guide will show you how to remove both the axle and the handle, so that you can replace either one or both.

Aletler

Hiçbir alete gerek yok.

Parçalar

Hiçbir parçaya gerek yok.

Assemble the required tools, including the Afridev tool and crescent wrenches.
  • Assemble the required tools, including the Afridev tool and crescent wrenches.

Yorum Ekle

Perform a water test on the pump, by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters.
  • Perform a water test on the pump, by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters.

Yorum Ekle

  • Loosen the bolt on front of the face plate with the Afridev tool.

  • Remove the plate from the pump by lifting it straight up.

Yorum Ekle

  • Insert the T-handle into the top cylinder of the exposed pump rod.

Yorum Ekle

  • Loosen the 2 bolts on either side of handle.

  • It is not necessary to remove the bolt at this time; however, take caution to not let the bolt fall out of the handle.

Yorum Ekle

  • Loosen the 2 bolts on either side of the head to remove the handle from the pump rod.

  • It is not necessary to remove the bolt at this time; however, take caution to not let the bolt fall out of the handle.

Yorum Ekle

  • Lift the handle to a horizontal position.

Yorum Ekle

  • While one person lifts up on the T-handle, remove the bolt and connection pieces.

Yorum Ekle

  • Remove the bolt and connection pieces from the handle.

  • Set the bolt pieces in a sanitary place, such as a bucket, to prevent contamination.

Yorum Ekle

  • Remove the handle from the pump.

  • Be sure to set the handle in a sanitary place to prevent contamination.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Jake Devincenzi

Üyelik tarihi: 18-04-2011

105.449 İtibar

57 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 2

Her zaman: 287