Ana içeriğe geç

Giriş

This guide requires you to use a soldering iron that can be dangerous if you do not know how to use it. I suggest looking at iFixit's Soldering Guide.

Parçalar

Hiçbir parça belirtilmedi.

  1. Hold the remote control with the backside facing you and, using the Phillips #00 screwdriver, unscrew the six 6.5 mm screws on the back of the controller that hold it together.
    • Hold the remote control with the backside facing you and, using the Phillips #00 screwdriver, unscrew the six 6.5 mm screws on the back of the controller that hold it together.

  2. Open the remote control.
    • Open the remote control.

  3. Lift the motherboard to separate it from the remote control.
    • Lift the motherboard to separate it from the remote control.

  4. To remove the light, use a soldering iron to heat the solder to a liquid and loosen the leads.
    • To remove the light, use a soldering iron to heat the solder to a liquid and loosen the leads.

    • While the solder is liquid, lightly pull on the LED to remove it from the motherboard.

    • The soldering iron will get very hot while it's in use. Be sure to place it on top of a heat protected surface and be careful not to touch the operational end.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Amber Ashley

Üyelik tarihi: 01-10-2015

329 İtibar

4 adet Kılavuz yazıldı

Takım

USF Tampa, Team 1-6, Leahy Fall 2015 USF Tampa, Team 1-6, Leahy Fall 2015 üyesi

USFT-LEAHY-F15S1G6

3 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 122