Eşyalarını Tamir Et Topluluk Mağaza

Drill Master Heat Gun Power Switch Replacement

Giriş

This requires soldering, so for a quick lesson or just a refresher, check out How to Solder and Desolder Connections.

Neye ihtiyacın var

  1. Drill Master Heat Gun Power Switch Replacement, Power Switch: adım 1, 1 resimden 1.

    • Be sure the heat gun is unplugged before starting this process.

    • Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.

    • You will need a screwdriver extension.

    Düzenle

  2. Drill Master Heat Gun Power Switch Replacement: adım 2, 1 resimden 1.

    • Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.

    • Don't try to open the casing just yet.

    Düzenle

  3. Drill Master Heat Gun Power Switch Replacement: adım 3, 3 resimden 1. Drill Master Heat Gun Power Switch Replacement: adım 3, 3 resimden 2. Drill Master Heat Gun Power Switch Replacement: adım 3, 3 resimden 3.

    • Remove the barrel casing on either end by twisting and pulling each side off.

    Düzenle

  5. Drill Master Heat Gun Power Switch Replacement: adım 4, 1 resimden 1.

    • Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

    Düzenle

  6. Drill Master Heat Gun Power Switch Replacement: adım 5, 1 resimden 1.

    • Loosen four screws on the wire connector using the flathead 2.5 screwdriver.

    • Screws do not come out of connector.

    Düzenle

  7. Drill Master Heat Gun Power Switch Replacement: adım 6, 1 resimden 1.

    • Squeeze the tabs on either side of the power switch to remove from the casing.

    Düzenle

  8. Drill Master Heat Gun Power Switch Replacement: adım 7, 2 resimden 1. Drill Master Heat Gun Power Switch Replacement: adım 7, 2 resimden 2.

    • Remove the black, plastic wire protectors from the end of the power switch.

    Düzenle

  9. Drill Master Heat Gun Power Switch Replacement: adım 8, 1 resimden 1.

    • Use soldering iron to remove the electrical wiring from the power switch. To replace the power switch, solder the new switch onto the wires.

    • Heating the soldering metal will allow you to pull off the electrical wiring.

    • For a brush-up on proper soldering, check out How to Solder and Desolder Connections.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Yazar

4 tane daha katılımcı ile

Mikayla Kim

Üyelik tarihi: 01/31/17

523 İtibar

5 adet Kılavuz yazıldı

Rozetler: 8

+5 tane daha rozet

Ekip

University of North Texas, Team 1-2, Campbell Spring 2017 University of North Texas, Team 1-2, Campbell Spring 2017 üyesi

UNT-CAMPBELL-S17S1G2

3 Üyeler

10 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 6

Son 30 gün: 20

Her zaman: 2,781