Eşyalarını Tamir Et Topluluk Mağaza

HP Envy 5660 Scanner Glass Replacement

Giriş

The scanner glass for the HP Envy 5660 may receive cracks over time. This guide will help the user replace the scanner glass.

Neye ihtiyacın var

  1. HP Envy 5660 Scanner Glass Replacement, Scanner Glass: adım 1, 1 resimden 1.

    • Open the cartridge access area.

    Düzenle

  2. HP Envy 5660 Scanner Glass Replacement: adım 2, 1 resimden 1.

    • Remove the three 11.5 mm screws with a T10 bit.

    Düzenle

  3. HP Envy 5660 Scanner Glass Replacement: adım 3, 3 resimden 1. HP Envy 5660 Scanner Glass Replacement: adım 3, 3 resimden 2. HP Envy 5660 Scanner Glass Replacement: adım 3, 3 resimden 3.

    • Locate the cover hinge on the right side of the printer.

    • Pull the hinge off of the scanner to allow the scanner to open to 90 degress.

    Düzenle

  5. HP Envy 5660 Scanner Glass Replacement: adım 4, 2 resimden 1. HP Envy 5660 Scanner Glass Replacement: adım 4, 2 resimden 2.

    • Remove the 12 mm screws on the left side of the printer with a T10 bit.

    Düzenle

  6. HP Envy 5660 Scanner Glass Replacement: adım 5, 2 resimden 1. HP Envy 5660 Scanner Glass Replacement: adım 5, 2 resimden 2.

    • Remove the 11.5 mm screw with a T10 bit to release the spring-loaded hinge.

    • Since this is a compression spring, the hinge will snap downwards as soon as it is loosened.

    Düzenle

  7. HP Envy 5660 Scanner Glass Replacement: adım 6, 3 resimden 1. HP Envy 5660 Scanner Glass Replacement: adım 6, 3 resimden 2. HP Envy 5660 Scanner Glass Replacement: adım 6, 3 resimden 3.

    • Pull the plastic side cover off of the printer.

    • You may need to lift the printer and push the cover downwards as it is latched onto the bottom of the printer.

    • Plastic opening tools or a metal spudger may also be used.

    Düzenle

  8. HP Envy 5660 Scanner Glass Replacement: adım 7, 1 resimden 1.

    • Remove the five 11.5 mm screws located at the bottom of the scanner.

    • Steps 3-6 were intended to create easier access to these screws. However, they will still be difficult to reach.

    • The top of the scanner will now easily pull off.

    Düzenle

  9. HP Envy 5660 Scanner Glass Replacement: adım 8, 2 resimden 1. HP Envy 5660 Scanner Glass Replacement: adım 8, 2 resimden 2.

    • Pry the old scanning glass up with a metal spudger.

    • There are adhesives under the scanning glass. Be careful not to break the glass while removing it.

    Düzenle

    This procedure also applies to the HP ENVY Photo 7155 !

    David Limbert - Yanıt

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Yazar

3 tane daha katılımcı ile

Ryan Steakley

Üyelik tarihi: 01/23/18

781 İtibar

5 adet Kılavuz yazıldı

Rozetler: 9

+6 tane daha rozet

Ekip

Cal Poly, Team S1-G6, Livingston Winter 2018 Cal Poly, Team S1-G6, Livingston Winter 2018 üyesi

CPSU-LIVINGSTON-W18S1G6

4 Üyeler

10 adet Kılavuz yazıldı

Bir Yorum

Remove an additional three 11.5 mm torx head screws in the same plane as step #4 photo, but near the hinges. This allows the cover hinges to be raised a bit for easier access to the screws removed in step #7. It also makes it easier to remove and reinstall the side cover.

My scanner glass was not broken, but inside surface had a dirty haze that was effecting my scans and needed cleaning. Thanks, I was ready to buy a new scanner.

Rich Monell - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 8

Son 30 gün: 20

Her zaman: 1,547