Hover-1 XLS LCD Screen Replacement

Giriş

The LCD Screen displays the status of the bike and is a clear indicator if your bike is on or off. Before beginning this replacement, you should know that it is a prerequisite to get to the ignition off. To get to the ignition, follow the ignition guide. You should also be able to solder. If you don't know how to solder, just follow the soldering guide in iFixit.

Neye ihtiyacın var

Adım 1 Ignition

Hover-1 XLS LCD Screen Replacement, Ignition: adım 1, 1 resimden 1.

Remove the six 16mm #3 Hex head screws located on the front panel.
The screws are held in with Teflon tape, so use a chemical remover like B'laster to loosen the screws.

Düzenle

Adım 2

Hover-1 XLS LCD Screen Replacement: adım 2, 3 resimden 3.

Grab the front panel and gently lift it up to the side.
The front panel is connected to the ignition, so don't pull too hard or the wires will get damaged.

Düzenle

Adım 3

Remove the two, 19 mm Phillips #2 screws holding the ignition.
Remove the yellow and red wires that are connected to the ignition. To remove them, look at the soldering guide provided by iFixit.