Logitech Harmony Smart Control Charging Port Replacement - iFixit Tamir Kılavuzu

Giriş

This guide requires soldering, for soldering guide click below.

Soldering Guide

Neye ihtiyacın var

Adım 1 Charging Port

Logitech Harmony Smart Control Charging Port Replacement, Charging Port: adım 1, 2 resimden 1.

Logitech Harmony Smart Control Charging Port Replacement, Charging Port: adım 1, 2 resimden 2.

Use the plastic opening tool to lift up the rubber pad.
With your fingers, pull back the rubber pad. This will expose the screw holes on the bottom of the device.
Repeat the step above for the second rubber pad on the bottom of the hub.

Adım 2

Logitech Harmony Smart Control Charging Port Replacement: adım 2, 2 resimden 1.

Logitech Harmony Smart Control Charging Port Replacement: adım 2, 2 resimden 2.

Using the PH00 bit, remove the four 6mm Phillips screws

Adım 3

Logitech Harmony Smart Control Charging Port Replacement: adım 3, 2 resimden 1.

Logitech Harmony Smart Control Charging Port Replacement: adım 3, 2 resimden 2.

Use the plastic opening tool to pry open and separate the pieces of plastic from each other.

Adım 4

Logitech Harmony Smart Control Charging Port Replacement: adım 4, 2 resimden 1.

Logitech Harmony Smart Control Charging Port Replacement: adım 4, 2 resimden 2.

Using the PH00 bit, remove the three 4mm Phillips screws.

Adım 5

Logitech Harmony Smart Control Charging Port Replacement: adım 5, 3 resimden 1.

Logitech Harmony Smart Control Charging Port Replacement: adım 5, 3 resimden 2.

Logitech Harmony Smart Control Charging Port Replacement: adım 5, 3 resimden 3.

Starting at the yellow corner, use a plastic opening tool to pry the circuit board from the housing.

Adım 6

Logitech Harmony Smart Control Charging Port Replacement: adım 6, 3 resimden 1.

Logitech Harmony Smart Control Charging Port Replacement: adım 6, 3 resimden 2.

Logitech Harmony Smart Control Charging Port Replacement: adım 6, 3 resimden 3.

Locate the defective charging port.
Turn the circuit board over to expose the charging solder.
Using a soldering iron, remove the solder and the charging port. Install a new charging port and solder.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Yazar

4 tane daha katılımcı ile

Josh Hendricks

Üyelik tarihi: 09/17/15

464 İtibar

4 adet Kılavuz yazıldı

+4 tane daha rozet

Ekip

IUPUI, Team 3-2, Harley Fall 2015 IUPUI, Team 3-2, Harley Fall 2015 üyesi

IUPUI-HARLEY-F15S3G2

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 4

Son 30 gün: 6

Her zaman: 707