Giriş

Regain the function of your speakers by replacing the audio board.

Unplug your MacBook Air and power it off before you proceed.
  • Unplug your MacBook Air and power it off before you proceed.

  • Remove ten Phillips screws securing the lower case to the MacBook Air:

    • Six 2.8 mm screws

    • Two 3.8 mm screws

    • Two 5.4 mm screws

Yorum Ekle

Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs. Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.
  • Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.

Yorum Ekle

Disconnect the battery connector by pulling it straight out of its socket.
  • Disconnect the battery connector by pulling it straight out of its socket.

Yorum Ekle

Remove the following nine screws securing the battery to the Air:
  • Remove the following nine screws securing the battery to the Air:

    • Four 2.9 mm Phillips.

    • Four 3.8 mm Phillips.

    • One 7.2 mm Phillips.

Yorum Ekle

Mac RAM Kitleri
Mac'inizi hızlandırın. Hafızasını en yükseğe çıkar.
Mac RAM Kitleri
Mac'inize daha fazla bellek alın.
Lift the battery out of the Air.
  • Lift the battery out of the Air.

Yorum Ekle

Remove the following two screws securing the speaker assembly to the upper case.
  • Remove the following two screws securing the speaker assembly to the upper case.

    • One 3 mm Phillips.

    • One 5.8 mm Phillips.

Yorum Ekle

Use a spudger to lift the audio-out connector board off the adhesive that secures it to the hard drive bracket. Disconnect the audio out connector from its socket.
  • Use a spudger to lift the audio-out connector board off the adhesive that secures it to the hard drive bracket.

  • Disconnect the audio out connector from its socket.

Yorum Ekle

Rotate the speaker assembly toward the center of the Air. Use a spudger to pry the speaker cable connector up off the audio board.
  • Rotate the speaker assembly toward the center of the Air.

  • Use a spudger to pry the speaker cable connector up off the audio board.

Yorum Ekle

Use the pointed end of a spudger to pry the speaker connector up off the audio board.
  • Use the pointed end of a spudger to pry the speaker connector up off the audio board.

Yorum Ekle

Insert the pointed end of a spudger into the gap around the audio board to pry it up off the adhesive securing it to the speaker housing.
  • Insert the pointed end of a spudger into the gap around the audio board to pry it up off the adhesive securing it to the speaker housing.

Yorum Ekle

Disconnect the audio out cable by pulling its connector straight away from the socket on the audio board.
  • Disconnect the audio out cable by pulling its connector straight away from the socket on the audio board.

Yorum Ekle

Audio board remains.
  • Audio board remains.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

9 başka kişi bu kılavuzu tamamladı.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 21

Son 30 Gün: 88

Her zaman: 19,441