Ana içeriğe geç

Nobis NB07 Cameras Replacement

Neye ihtiyacın var

  1. Nobis NB07 Cameras Replacement, Opening the case: adım 1, 1 resimden 1.
    • Look towards the topside of the tablet, where the power button is located.

    • Insert a plastic opening tool in the crack between the two parts of the case.

    • Move it gently back and forth to open the case.

  2. Nobis NB07 Cameras Replacement: adım 2, 3 resimden 1. Nobis NB07 Cameras Replacement: adım 2, 3 resimden 2. Nobis NB07 Cameras Replacement: adım 2, 3 resimden 3.
    • With the plastic opening tool in the opening between the two sides of the case, slide the tool along the tablet's border to separate the two sides completely.

    • Be careful when you separate the two halves. Open the case from the opposite side of the camera, there is a cable connecting both halves of the case.

  3. Nobis NB07 Cameras Replacement, Replacing the battery: adım 3, 3 resimden 1. Nobis NB07 Cameras Replacement, Replacing the battery: adım 3, 3 resimden 2. Nobis NB07 Cameras Replacement, Replacing the battery: adım 3, 3 resimden 3.
    • Remove the tape holding the battery in place.

  4. Nobis NB07 Cameras Replacement: adım 4, 3 resimden 1. Nobis NB07 Cameras Replacement: adım 4, 3 resimden 2. Nobis NB07 Cameras Replacement: adım 4, 3 resimden 3.
    • Insert the flat end of the spudger tool in the crack beneath the battery.

    • Move the spudger tool carefully side to side to remove the glue that is holding the battery in place.

    • This is a soft battery, so a little bending is expected.

  5. Nobis NB07 Cameras Replacement: adım 5, 1 resimden 1.
    • After the battery is unglued, locate the cables that connect it to the motherboard.

    • Annotate where each color goes to make the reassembly easier.

  6. Nobis NB07 Cameras Replacement: adım 6, 2 resimden 1. Nobis NB07 Cameras Replacement: adım 6, 2 resimden 2.
    • Desolder the cables with a soldering iron and use a desoldering braid to remove the solder.

    • Review the Ifixit soldering guide if you need help soldering.

    • You can now remove the battery.

  7. Nobis NB07 Cameras Replacement, Removing the cameras: adım 7, 3 resimden 1. Nobis NB07 Cameras Replacement, Removing the cameras: adım 7, 3 resimden 2. Nobis NB07 Cameras Replacement, Removing the cameras: adım 7, 3 resimden 3.
    • Remove the black tape covering the cameras power cable.

  8. Nobis NB07 Cameras Replacement: adım 8, 2 resimden 1. Nobis NB07 Cameras Replacement: adım 8, 2 resimden 2.
    • Use the spudger tool to pry upwards the ZIF connector and release the power cable.

  9. Nobis NB07 Cameras Replacement: adım 9, 3 resimden 1. Nobis NB07 Cameras Replacement: adım 9, 3 resimden 2. Nobis NB07 Cameras Replacement: adım 9, 3 resimden 3.
    • With the power cable disconnected, the backside camera is free. However, both cameras are sequentially connected through the power cable; the front side camera is glued to the motherboard.

    • Using tweezers, carefully grab the front camera and twist slowly.

    • The camera should release easily, do not twist too hard.

    • You can now remove the cameras.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Daniel Gomero

Üyelik tarihi: 01/21/15

966 İtibar

5 adet Kılavuz yazıldı

Ekip

USF Tampa, Team 5-5, Brown Winter 2015 USF Tampa, Team 5-5, Brown Winter 2015 üyesi

USFT-BROWN-W15S5G5

3 Üyeler

10 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 1

Her zaman: 121