Ana içeriğe geç

What you need

  1. Samsung Galaxy Watch Display Replacement, Opening Procedure: adım 1, 1 resimden 1.
    • Remove the four Tri-point #00 screws (4.2 mm length) on the backside of the watch.

  2. Samsung Galaxy Watch Display Replacement: adım 2, 2 resimden 1. Samsung Galaxy Watch Display Replacement: adım 2, 2 resimden 2.
    • Use an opening tool to get between the back cover and the metal housing of the watch.

    • Carefully pry the plastic back cover open.

    • Don't remove the back cover yet. There is a flex cable running to the core assembly inside.

  3. Samsung Galaxy Watch Display Replacement: adım 3, 2 resimden 1. Samsung Galaxy Watch Display Replacement: adım 3, 2 resimden 2.
    • Lay down the watch and lift the back cover to access the sensor connector on the motherboard.

  4. Samsung Galaxy Watch Display Replacement: adım 4, 2 resimden 1. Samsung Galaxy Watch Display Replacement: adım 4, 2 resimden 2.
    • Use a spudger to disconnect the sensor flex cable from the motherboard.

  5. Samsung Galaxy Watch Display Replacement: adım 5, 3 resimden 1. Samsung Galaxy Watch Display Replacement: adım 5, 3 resimden 2. Samsung Galaxy Watch Display Replacement: adım 5, 3 resimden 3.
    • Remove the back cover.

    • When closing the watch make sure the rubber gasket is undamaged or replace it with a new one.

  6. Samsung Galaxy Watch Display Replacement, Core Assembly Removal: adım 6, 2 resimden 1. Samsung Galaxy Watch Display Replacement, Core Assembly Removal: adım 6, 2 resimden 2.
    • Use a spudger to disconnect the display flex cable from the motherboard.

  7. Samsung Galaxy Watch Display Replacement: adım 7, 2 resimden 1. Samsung Galaxy Watch Display Replacement: adım 7, 2 resimden 2.
    • Lift the core unit out of the housing.

    • The core's plastic frame sits tight inside the housing.

    • Carefully thread the display flex cable through the gap of the core's plastic frame.

  8. Samsung Galaxy Watch Display Replacement, Display: adım 8, 1 resimden 1.
    • If necessary apply some tape over the display to avoid any injury from glass shards.

  9. Samsung Galaxy Watch Display Replacement: adım 9, 2 resimden 1. Samsung Galaxy Watch Display Replacement: adım 9, 2 resimden 2.
    • Use your finger or thumb to steadily push down on the display to loosen the adhesive.

    • Heating the display with a hair dryer or iOpener helps softening the adhesive.

    • Remove the display.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

8 farklı kişi bu kılavuzu tamamladı.

Tobias Isakeit

Üyelik tarihi: 31-03-2014

105.945 İtibar

186 adet Kılavuz yazıldı

Team

iFixit iFixit üyesi

Community

141 Üyeler

15.861 adet Kılavuz yazıldı

0 Comments

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 45

Son 7 gün: 342

Son 30 gün: 1,700

Her zaman: 31,138