Giriş

If you have not fixed your problem through our Troubleshooting Guide, then you may have to replace your Hard Drive.

Hazards

Keep out of reach of children and pets.

DO NOT attempt to teardown or repair your device under the influence of drugs or alcohol.

DO NOT ingest any parts of the system.

Use the correct tools as stated in the tools section.

DO NOT touch any gold connectors on interior or exterior of the system.

Make sure system is unplugged before performing any maintenance on the system.

NOTICE

Make sure your replacement hard drive is a serial ATA hard drive (SATA). Any other hard drive will be incompatable.

Set the computer display-side down.
  • Set the computer display-side down.

  • Unlock the battery by sliding the port-side latch to the 'unlock' position.

Yorum Ekle

On the opposite side of the battery, press the release latch and slide the battery away from the main body to remove.
  • On the opposite side of the battery, press the release latch and slide the battery away from the main body to remove.

Yorum Ekle

Ignore the removal of the heat sink and memory panels as depicted. They do not need to be removed for the completion of this guide.
  • Ignore the removal of the heat sink and memory panels as depicted. They do not need to be removed for the completion of this guide.

  • Remove the Torx security screw near the center of the battery-side edge.

Yorum Ekle

Press the tabs on each side of the display-side of the keyboard with the flat edge of a spudger. Pull the keyboard toward the mouse pad and gently lift up.
  • Press the tabs on each side of the display-side of the keyboard with the flat edge of a spudger.

  • Pull the keyboard toward the mouse pad and gently lift up.

Yorum Ekle

The keyboard is still attached by ribbon cable, don't try to remove the keyboard entirely yet. Disconnect the ribbon cable by pressing the tabs on either side of the connector. Pull the cable out parallel to the connector.
  • The keyboard is still attached by ribbon cable, don't try to remove the keyboard entirely yet.

  • Disconnect the ribbon cable by pressing the tabs on either side of the connector. Pull the cable out parallel to the connector.

  • Remove the keyboard.

Yorum Ekle

Turn the laptop upside down.
  • Turn the laptop upside down.

  • Remove the three screws from the front mouse panel located on the bottom of the laptop.

  • Carefully flip the laptop back over. Remove three more screws from the top securing the panel. A ribbon cable will still be attached to the panel when you remove it.

Yorum Ekle

Lift the mouse assembly just enough to access the connecting ribbon cable. Lift the ribbon cable lock to remove the cable.
  • Lift the mouse assembly just enough to access the connecting ribbon cable.

  • Lift the ribbon cable lock to remove the cable.

  • Carefully remove the mouse panel assembly and set aside.

Yorum Ekle

This is where your hard drive would be located. The replacement must be a Serial ATA(SATA) hard drive
  • This is where your hard drive would be located. The replacement must be a Serial ATA(SATA) hard drive

  • Remove the four hard drive securing screws.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

16 başka kişi bu kılavuzu tamamladı.

Ashley Brooks

Üyelik tarihi: 09-04-2010

264 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 25-89, Amido Spring 2010 Cal Poly, Team 25-89, Amido Spring 2010 üyesi

CPSU-AMIDO-S10S25G89

4 Üyeler

52 adet Kılavuz yazıldı

Bir Yorum

simple and perfect in every detail

francesco - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 7

Son 7 Gün: 70

Son 30 Gün: 312

Her zaman: 28,430