Ana içeriğe geç

Giriş

This guide walks you through how to replace a broken speaker on your UnBranded Tablet.

  1. Remove the cover over the Micro SD outlet by using a plastic opening tool to pry open and push out the cover panel.
    • Remove the cover over the Micro SD outlet by using a plastic opening tool to pry open and push out the cover panel.

  2. Remove the two 4-mm #0 screws from the inside of the Micro SD compartment.
    • Remove the two 4-mm #0 screws from the inside of the Micro SD compartment.

  3. Insert  blue guitar picks in the crease between the top and bottom panels starting on the same end as the Micro SD slot. Inserting the picks directly under the Micro SD compartment was the easiest place to get started.  It still requires some force.
    • Insert blue guitar picks in the crease between the top and bottom panels starting on the same end as the Micro SD slot.

    • Inserting the picks directly under the Micro SD compartment was the easiest place to get started. It still requires some force.

  4. Insert the black spudger between the guitar picks in order to pry open gaps between the blue guitar picks.
    • Insert the black spudger between the guitar picks in order to pry open gaps between the blue guitar picks.

    • As the gaps open, slide the guitar picks along the sides to separate the panels.

  5. Pry all four sides apart using the blue guitar picks and the black spudger until they can easily be pried apart by hand.
    • Pry all four sides apart using the blue guitar picks and the black spudger until they can easily be pried apart by hand.

  6. Remove the yellow tape from the speaker.
    • Remove the yellow tape from the speaker.

  7. Remove the two 4-mm #0 screws holding the speaker in place.
    • Remove the two 4-mm #0 screws holding the speaker in place.

    • The copper-colored plastic piece covering the speaker does not need to be removed from the device, move it to the side to reach the screws.

  8. Remove the silver tape covering the speaker's black and red wires.
    • Remove the silver tape covering the speaker's black and red wires.

  9. Reflow the solder of the black and red wires from the circuit board by using the soldering iron.
    • Reflow the solder of the black and red wires from the circuit board by using the soldering iron.

    • For more information about using a soldering iron click here.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Jordan Turk

Üyelik tarihi: 21-09-2015

331 İtibar

2 adet Kılavuz yazıldı

Takım

IUPUI, Team 2-1, Baechle Fall 2015 IUPUI, Team 2-1, Baechle Fall 2015 üyesi

IUPUI-BAECHLE-F15S2G1

3 Üyeler

3 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 4

Her zaman: 640