Eşyalarını Tamir Et Topluluk Mağaza

Giriş Geçmişi: Mavic 2 Main Board Replacement

Düzenleyen: Robert Contraction —

Düzenleme onaylandı tarafından Robert Contraction

Önce
Sonra
Değiştirilmemiş
Cihaz
Mavic 2
Type
replacement
Thing
Main Board
Title
Mavic 2 Main Board Replacement
Introduction
# Turn drone upside down to expose underside plate.
# Begin to remove all 8 screws from the plate . Remember the 2 middle screws are bigger than the other 6 so set those aside separately.
# Pull plate off, exposing the main board.
# Detach 3 ribbons on the top of the board. Near the head of the drone. Use spreader.
# Remove screw holding circuit board in. 1 near the top, 2 near the bottom.
# Pop of all 4 antennas at the bottom of the circuit board. Use spreader.
# Pull away antennas and remove board carefully.
# Replace new circuit board.
# Attach 3 ribbons.
# Attach 4 antennas.
# Screw circuit board back in.
# Place the plate back on and screw back in all 8 screws.
Time Required Min
Tahmin yok
Time Required Max
Tahmin yok
Imageid
Önce
Sonra
Difficulty
Moderate
Conclusion
To reassemble your device, follow these instructions in reverse order.
Author
Robert Contraction
Public
Hayır

İşaretler

  • In Progress added.
  • Community-Contributed Guide added.

Adımlar

Adım #: 1
Önce
Sonra
stepid 251759 stepid 251759
Adım #: 2
Önce
Sonra
stepid 251761 stepid 251761
Adım #: 3
Önce
Sonra
stepid 251764 stepid 251764