5. Adımdaki Değişiklikler
Düzenleyen: Eric Arnold —
Düzenleme onaylandı tarafından Eric Arnold
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| [* red] Insert two of your 7mm T7 Torx screws into the indicated posts on the powersupply/heatsink. | |
| [* black] Using screw removal pliers, pull up on the screws, alternating between them, until the unit is free from the case. | |
| - | [* icon_note] The fit between the case and the powersupply/heatsink is very tight. |
| + | [* icon_note] The fit between the case and the powersupply/heatsink is very tight. However, the powersupply should fall freely into place on reassembly. |