12. Adımdaki Değişiklikler
Düzenleyen: Pavel Hanak —
Düzenleme onaylandı tarafından Pavel Hanak
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| [title] Networked functionality test | |
| [* black] Connect Ethernet cable to the printer and check the ASCII GUI. Normally, some values change every second and they should continue to do so after you plug in the cable. If the firmware freezes, you need to check the BIOS settings again. | |
| - | [* black] Moreover, the firmware displays various information during boot. If you reboot the printer and it always freezes at a particular stage, then |
| - | [* black] The printer should now work normally. You should be immediately able to connect to it with ZPrint or XXXXXXXX software, because all settings were stored on its internal HDD. But keep in mind the new mainboard has different MAC address, so some network |
| + | [* black] Moreover, the firmware displays various information during boot. If you reboot the printer and it always freezes at a particular stage, then that's the likely culprit. Unfortunately, it seems the only way to do a reboot from frozen firmware is by turning the printer off and on again. |
| + | [* black] The printer should now work normally. You should be immediately able to connect to it with ZPrint or XXXXXXXX software, because all settings were stored on its internal HDD. But keep in mind the new mainboard has different MAC address, so some network configuration changes in your institution/workplace may be necessary. |