Raptor X Axis Linear Rail Install 1 No'lu Adım Geçmişi

	[title] Preparing / Disassembly 1a.
	[* icon_caution] After moving Z to 250mm above the bed and removing filament, Power Off, Power Cables UNPLUGGED!
	[* icon_note] Remove printhead cable and control box and set aside.
-	[* icon_reminder] You will need access to the back of the machine as well as the front. Give yourself enough room to rotate the machine if not work all they way around.
+	[* icon_reminder] You will need access to the back of the machine as well as the front. Give yourself enough room to rotate the machine if not work all they way around. *Another tip* is to place a piece of cardboard on the build surface to use a place to work.
	[* icon_note] If you have access to compressed air, blow the machine off. Use this time to clean the machine and give yourself good lighting to look over all the components thoroughly.
	[* black] Using a M2.5 hex and 8mm open end wrench, loosen the bottom inner wheel eccentric locknut. Back it off a few turns.
	[* black] Using a 7mm closed end wrench hold the nylock nut on the front of the X/Z bracket and loosen the eccentric wheel shaft with the M2.5 hex.
	[* black] Fully remove both lower inner wheels. They will not be used.
	[* icon_note] 3 points is superior to 4 in this case.