3. Adımdaki Değişiklikler
Adım Satırları
| + | [title] Unbind the clips around the controller. |
|---|---|
| + | [* black] Using a plastic spudger, a metal flat spudger or flat-head screwdriver, and a coin pick, separate the top shell from the bottom by undoing the many clips around the controller. |
| + | [* icon_reminder] Only use a metal spudger or screwdriver for more leverage to pry off each clip, repeated mistakes as you pry apart the controller can damage the outer shell. |
| + | [* blue] Start from the top of the controller by the USB-C port, insert the spudger into a crease between the middle of the top and the bumpers, and carefully pry apart the gap. |
| + | [* icon_caution] Once you hear a loud snap, it likely means a clip is unbound successfully. When this happens, ''do not pry more on the same spot'', and use the plastic spudger or coin pick to keep that area separated as you move to a nearby gap and pry apart there with a stronger spudger or pick. |
| + | [* yellow] Continue from the top, working down the side of the controller along the outside of the handles, to the bottom by the headphone jack. |
| + | [* black] Repeat this process for the other side of the controller, starting from a gap near the other bumper button, work along the opposite handle and meet at the other side of the headphone jack. |
| + | [* icon_reminder] There are a lot of clips, at least 10 large clips on the top frame and even more little clips along the edge of the bottom chassis. This process will take some time, especially if you want to retain the quality of the outer shell as best as possible. |
Resim 1
Önceki resim yok
Eklendi
Resim 2
Önceki resim yok
Eklendi
Resim 3
Önceki resim yok
Eklendi