2. Adımdaki Değişiklikler
Düzenleyen: Nick Schultz —
Düzenleme onaylandı tarafından Nick Schultz
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| [title] Remove the tape | |
| - | [* black] Use your fingernail to peel up and grab the edge of the black tape holding the camera connector in place. |
| - | [* black] Unravel the tape until the connector is free. |
| - | [* black] If the connector is stuck, insert your fingernail beneath it and lift up to disconnect it from the PCB. |
| + | [* black] Use your fingernail or the point of a spudger to peel up the edge of the black tape holding the camera connector in place. |
| + | [* black] Completely unravel the tape. |
| + | [* black] Insert your fingernail or the flat end of a spudger beneath the camera module [guide|25629|press connector|stepid=70308|new_window=true] and lift up to disconnect it from the board. |
| + | [* icon_reminder] During reassembly, connect the press connector first, then replace the tape. |