Sony Cyber-shot DSC-W290 Flash Bulb Assembly Replacement 2 No'lu Adım Geçmişi

-	[* black] Carefully remove the right ribbon-wire from the top camera panel by pulling where the wire connects to the top.
+	[* black] Tilt top casing up and towards you.
+	[* black] Carefully remove the right ribbon-wire from the top camera panel by pulling where the wire connects to the top.
	[* icon_note] Make sure to hold the camera with your thumb on the white square to ensure the ribbon-wire is not disconnected from the logic board.
	[* black] Carefully remove the left ribbon-wire from the top camera panel by pulling where the wire connects to the top.
	[* icon_caution] To continue with this guide, you need to have soldering equipment. If you do not need to replace the flash bulb and are just removing this part, skip the next steps about soldering.