34. Adımdaki Değişiklikler
Düzenleyen: Jake Devincenzi —
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| - | [* black] Give the plastic beads a few seconds to cool |
|---|---|
| + | [* black] Give the plastic beads a few seconds to cool, then remove them and mash them together until they form one piece. |
| [* icon_caution] The plastic beads should be fairly warm still, but their container will likely be extremely hot. Use care when removing and handling the beads. | |
| [* black] Stretch the glob of plastic into a thin strip that will fill one of the gaps between the case halves. | |
| [* black] Press the plastic into the crevices and smooth it out with your finger. | |
| [* icon_note] If the plastic becomes too hard to work with, you can re-apply heat to loosen the plastic. | |
| [* icon_caution] Be cautious if you reheat the plastic while it's in the case. Allow cooling periods between reheating so you don't accidentally de-solder any components. |