24. Adımdaki Değişiklikler
Düzenleyen: Chayton Ritter —
Düzenleme onaylandı tarafından Chayton Ritter
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [title] Surface mount components are significantly smaller than through-hole components, making them difficult to solder by hand. But |
|---|---|
| + | [* black] The next 6 steps will show you how to solder surface-mount components onto a circuit board. You'll need a ***[product|IF317-021-4|fine-tipped soldering iron|new_window=true]*** in addition to the following: |
| + | [* red] Solder wire ([product|IF317-058|leaded|new_window=true] or [product|IF145-077-2|lead-free|new_window=true]) or solder paste |
| + | [* orange] [product|IF317-056|Flux|new_window=true] |
| + | [* yellow] [product|IF317-047|Tweezers|new_window=true] and [product|IF145-059|picks|new_window=true] to help manipulate the tiny components |
| + | [* green] A tip cleaning tool (wet sponge or [product|IF317-032|brass wire|new_window=true]) |
| + | [* light_blue] A magnifying glass or lens |
| + | [* blue] A [guide|170836|fume extractor|new_window=true] (if you're working indoors) |
| + | [* violet] High concentration (>90%) isopropyl alcohol and a [product|IF145-062|soft bristle brush|new_window=true] (like a toothbrush) |
Resim 1
Önceki resim yok
Eklendi
Resim 2
Önceki resim yok
Eklendi