8. Adımdaki Değişiklikler
Düzenleyen: Jake Devincenzi —
Düzenleme onaylandı tarafından Jake Devincenzi
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| - | [* black] Place the new battery in place and align the far contact with the outer solder |
|---|---|
| + | [* black] Place the new battery in place and align the far contact with the outer solder pad. Use a small strip of electrical tape to hold the cable against the solder pads. |
| [* icon_caution] Installing the battery upside down (with the cable facing up) will destroy the logic board. | |
| [* black] Place the strip of tape over the end of the battery ribbon cable to both cover two of the solder pads and hold the contacts down against the logic board. | |
| [* black] Heat the rightmost contact until the solder below melts, then apply a small amount of solder to the contact, allowing it to flow through the two holes in the cable and down to the logic board. | |
| [* icon_caution] Do not apply too much solder. The amount required for a proper bond is miniscule. | |
| [* black] As soon as the solder has flowed into the joint, remove both the solder and the iron. |