Repeat the previous steps for the five remaining vise clamps: one at each of the four corners, and one in the middle of each long edge.

For larger tablets, more than six vise clamps may be needed to ensure the adhesive bonds evenly around the entire perimeter.

Using a hair dryer or heat gun, evenly heat the edges all the way around the device until they are slightly too hot to touch. The heat will help the adhesive form a more complete bond.

Don't overheat the device, or you may cause the battery to ignite or damage other heat-sensitive components, like the display.

While the device is still hot, tighten all six vise clamps down one full turn.

Don't tighten any further to avoid damaging your device.

Leave the vise clamps in place for about thirty minutes.