Ana içeriğe geç
Yardım

Xbox 360 S Heat Sink Replacement

Adım 1 Düzenleniyor —

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız bütün değişiklikler bu adımın yer aldığı diğer kılavuzları da etkileyecektir.

Adım Tipi:

Yeniden düzenlemek için sürükleyin

Turn the logic board assembly over to access the heat sink's x-clamp.

To avoid ESD damage, be sure to lay your logic board on a soft, static free surface during service.

The logic board is very sensitive to impact and scratching. Be sure to not let the screwdriver slip and damage the logic board.

Starting at the front left corner of the x-clamp, insert a 1.5 mm flathead screwdriver between the heat sink's peg and the x-clamp's hook.

If you're worried about scratching the logic board, insert a spudger or thin screwdriver down through one of the holes in the x-clamp, in the gap just inside the screw post. Pry outward to release the x-clamp. Repeat for the opposite arm.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.