Ana içeriğe geç

Reemplazo de batería del timbre con video Ring Pro

İngilizce
İspanyolca

Adım 10 çevriliyor

Adım 10
Ring Video Doorbell Pro Battery Replacement: adım 0, 1 resimden 1.
  • You need to be very careful on this step, if you touch the battery with the soldering iron the battery may explode.

  • Do NOT heat up the battery too much or it may also explode, you need to be quick doing the soldering.

  • Remove the clear tape from the old battery.

  • De-solder the old battery circuit from the old battery.

  • You will need this circuit, so be careful not to damage it!

  • De-solder the battery circuit that comes with the new cell, and solder the battery circuit from the old ring battery to the new battery. This will convert your new cell to a cell compatible with the Ring's charging circuitry.

  • Make sure to observe polarities. The solder pad with the red wire next to it goes to the '+' poll on the battery, and the solder pad with the black wire goes to the '-' poll on the battery.

Debes tener mucho cuidado en este paso, si tocas la batería con el soldador, la batería puede explotar.

NO calientes demasiado la batería o también podría explotar, debe ser rápido al soldar.

Quita la cinta transparente de la batería vieja.

Desuelda el circuito de la batería vieja de la batería vieja.

Necesitarás este circuito, ¡así que ten cuidado de no dañarlo!

Desuelda el circuito de la batería que viene con la nueva celda y suelda el circuito de la batería del anillo antiguo a la batería nueva. Esto convertirá tu nueva celda en una celda compatible con el circuito de carga del Ring.

Asegúrate de observar las polaridades. La almohadilla de soldadura con el cable rojo al lado va a la casilla '+' de la batería, y la almohadilla de soldadura con el cable negro va a la casilla '-' de la batería.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.