Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 4 kılavuzları etkileyecektir.
Adım 3 çevriliyor
Adım 3
Remove the old adhesive
-
If you are re-using your existing display, you must also remove the old adhesive from the back of the display.
-
Peel off the adhesive strips using tweezers or your fingers. Start at the bottom and peel upward towards the top of the device.
-
After all the old adhesive is removed, carefully clean the surface with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth.
| [title] Remove the old adhesive | |
| [* icon_note] Before you install new adhesive strips, remove all of the old adhesive from the perimeter of the rear enclosure. | |
| [* black] If you are re-using your existing display, you must also remove the old adhesive from the back of the display. | |
| - | [* black] Peel off the adhesive strips using tweezers or your fingers. Start at the bottom and peel ''upward'' towards the top of the device. |
| + | [* black] Peel off the adhesive strips using [product|IF145-020|tweezers] or your fingers. Start at the bottom and peel ''upward'' towards the top of the device. |
| [* black] After all the old adhesive is removed, carefully clean the surface with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth. | |
| [* icon_caution] ***Don't skip this step***, or your new adhesive strips may not bond properly, and the display may fall out of your iMac. |
Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.