Ana içeriğe geç

Sustitución de tiras adhesivas iMac Intel 27" 2012-2015

İngilizce
İspanyolca
Adım 3
iMac Intel 27" 2012-2015 Adhesive Strips Replacement, Remove the old adhesive: adım 0, 2 resimden 1. iMac Intel 27" 2012-2015 Adhesive Strips Replacement, Remove the old adhesive: adım 0, 2 resimden 2.
Remove the old adhesive
  • Before you install new adhesive strips, remove all of the old adhesive from the perimeter of the rear enclosure.

  • If you are re-using your existing display, you must also remove the old adhesive from the back of the display.

  • Peel off the adhesive strips using tweezers or your fingers. Start at the bottom and peel upward towards the top of the device.

  • After all the old adhesive is removed, carefully clean the surface with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth.

  • Don't skip this step, or your new adhesive strips may not bond properly, and the display may fall out of your iMac.

Antes de instalar tiras adhesivas nuevas, retira todo el adhesivo antiguo del perímetro de la carcasa trasera.

Si estás reutilizando una pantalla anterior ya existente, también debes quitar el adhesivo viejo de la parte posterior de la pantalla.

Retira las tiras adhesivas con pinzaso con los dedos. Comienza en la parte inferior y pela hacia arriba hacia la parte superior del dispositivo.

Después de quitar todo el adhesivo antiguo, limpia con cuidado la superficie con alcohol isopropílico al 90 % (o más) y un paño sin pelusa. Limpia en una dirección, no de un lado a otro.

No te saltes este paso o es posible que tus nuevas tiras adhesivas no se adhieran correctamente y la pantalla se caiga de tu iMac.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.