Ana içeriğe geç

Sostituzione del circuito del lettore di schede di gioco di Nintendo Switch – Modello OLED

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 10 kılavuzları etkileyecektir.

İngilizce
İtalyanca

Adım 3 çevriliyor

Adım 3
Nintendo Switch OLED Model Game Card Reader Daughterboard Replacement, Remove the daughterboard: adım 0, 3 resimden 1. Nintendo Switch OLED Model Game Card Reader Daughterboard Replacement, Remove the daughterboard: adım 0, 3 resimden 2. Nintendo Switch OLED Model Game Card Reader Daughterboard Replacement, Remove the daughterboard: adım 0, 3 resimden 3.
Remove the daughterboard
  • The bottom of the daughterboard is connected to the motherboard via a press connector.

  • Insert a spudger between the edge of the daughterboard and the motherboard.

  • Pry up with the spudger to disconnect the press connector and separate the daughterboard from the frame.

  • Remove the daughterboard.

  • To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage.

La parte inferiore della scheda elettronica è connessa alla scheda madre tramite un connettore a pressione.

Inserisci uno spudger fra il bordo della scheda elettronica e la scheda madre.

Fai leva verso l'alto con uno spudger per disconnettere il connettore a pressione ed allontanare la scheda elettronica dal telaio.

Rimuovi la scheda elettronica.

Per riposizionare in sede i connettori a pressione come questo, allinealo con cura e premi verso il basso su un lato finché non scatta in posizione, quindi ripetere sull'altro lato. Non premere al centro. Se il connettore è disallineato, i pin possono piegarsi, causando danni permanenti.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.