Eşyalarını Tamir Et Topluluk Mağaza

4. Instalando Klipper en SKR3 EZ

Kılavuza Dön
İngilizce
İspanyolca
Adım 9
4. Installing Klipper on SKR3 EZ, For UART and USB Connected Boards: adım 0, 2 resimden 1. 4. Installing Klipper on SKR3 EZ, For UART and USB Connected Boards: adım 0, 2 resimden 2.
For UART and USB Connected Boards

  • Compile the firmware by running

  • Make

  • The SKR3 doesn't have a bootloader so you cannot flash it from the RPI. You'll need to use the SD method.

  • Open WINSCP

  • Navigate to /klipper/out/

  • Copy klipper.bin to your PC and rename it to firmware.bin

  • Copy firmware.bin to a SD. I used a 128mb one I had laying around

  • Holding the RESET button on the SKR3 EZ, insert the SD card into the SKR3 EZ.

Para las placas UART y conectadas por USB

Compila el firmware ejecutando:

Make

el SKR3 no tiene bootloader asi que no podras flashearlo desde el RPI, necesitaras usar el método SD

Abre WINSCP

Navega a /klipper/out/

Copia klipper.bin en tu computadora y renómbralo a firmware.bin

Copia firmware.bin a la SD. Yo use una de 128mb que tenia de sobra.

Sosteniendo el botón RESET en el SKR3 EZ, inserta la memoria SD en el SKR3 EZ

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.