Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız bütün değişiklikler bu adımın yer aldığı diğer kılavuzları da etkileyecektir.
Adım 4 çevriliyor
Adım 4
Remove the Touch ID sensor bracket
-
Use a 3IP Torx Plus screwdriver to remove the six screws securing the Touch ID sensor and its bracket:
-
Four 2 mm‑long screws
-
Two 1.7 mm‑long screws
-
Install the screws without fully tightening them.
-
Open your MacBook and align the Touch ID sensor on the keyboard.
-
Close your MacBook and fully tighten the screws.
Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.