Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 3 kılavuzları etkileyecektir.
Adım 3 çevriliyor
Adım 3
-
On the bottom of the camera, remove the following screws:
-
Four M1.7x5.0mm Phillips #000 screws
-
Using a plastic opening pick, partially peel up the top of the back rubber grip.
-
Carefully begin lifting the back cover up away from the camera body.
-
Using a plastic spudger tool, gently pry off the back cover ribbon cable from the main PCB board.
Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.