Eşyalarını Tamir Et Topluluk Mağaza

iPhone 16 Pro Max 充電ポートの交換

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız bütün değişiklikler bu adımın yer aldığı diğer kılavuzları da etkileyecektir.

Kılavuza Dön
İngilizce
Japonca
Adım 4
iPhone 16 Pro Max Charge Port Installation: adım 0, 3 resimden 1. iPhone 16 Pro Max Charge Port Installation: adım 0, 3 resimden 2. iPhone 16 Pro Max Charge Port Installation: adım 0, 3 resimden 3.

  • Use a Phillips screwdriver to install the two 3.3 mm‑long screws securing the charge port to the frame.

  • Be careful not to press the screwdriver against the battery.

プラスドライバーを使い、充電ポートをフレームに固定している長さ3.3mmのネジ2本を外します。

これらのネジは固く、手が届きにくい場合があります。ドライバーの角度はできるだけ浅くし、バッテリーを押さないように注意してください。

充電ポートを取り付ける際、ポートの位置合わせを助けるため、外側のP2ペンタローブネジ2本を仮に取り付けます。位置が合ったら、プラスネジでポートを固定してください。

ペンタローブネジを外さなければ、背面ガラスを取り付ける際に邪魔になります。

-[title] Remove the charge port
-[* green] Use a Phillips screwdriver to remove the two 3.3 mm‑long screws securing the charge port to the frame.
- [* icon_note] These screws are tight and can be difficult to reach. Angle your screwdriver at as shallow of an angle as you can, ***but be careful not to press against the battery***.
-[* icon_reminder] When you're installing the charge port, [link|https://guide-images.cdn.ifixit.com/igi/V2QaUJcX1ZRmi4JI.full|temporarily install the two external P2 pentalobe screws to help with port alignment|new_window=true]. Once it's aligned, secure the port with its Phillips screws.
- [* icon_caution] Remove the pentalobe screws after this, or they'll block you from installing the back glass.
+[* green] Use a Phillips screwdriver to install the two 3.3 mm‑long screws securing the charge port to the frame.
+ [* icon_caution] Be careful not to press the screwdriver against the battery.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.