Ana içeriğe geç

iPhone 6 Plus 前面板组件更换

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız herhangi bir değişiklik bu adımın yer aldığı bütün 18 kılavuzları etkileyecektir.

İngilizce
Çince
Adım 9
iPhone 6 Plus Front Panel Assembly Replacement: adım 0, 1 resimden 1.
  • Remove the following Phillips screws securing the front panel assembly cable bracket:

  • Three 1.2 mm screws

  • One 1.5 mm screw

  • One 2.9 mm screw

  • Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.

保持前面板张开立起约90度,卸下前面板排线固定板上的五颗Phillips螺丝。

三颗1.2 mm螺丝

一颗1.7 mm螺丝

一颗3.1mm螺丝

-[* black] While holding the front panel open at about a 90º angle, remove the following screws securing the front panel assembly cable bracket:
- [* red] Three 1.2 mm Phillips #00 screws
- [* orange] One 1.5 mm Phillips #00 screw
- [* yellow] One 2.9 mm Phillips #00 screw
+[* black] Remove the following Phillips screws securing the front panel assembly cable bracket:
+ [* red] Three 1.2 mm screws
+ [* orange] One 1.5 mm screw
+ [* yellow] One 2.9 mm screw
+[* icon_caution] ***Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.***

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.