Eşyalarını Tamir Et Topluluk Mağaza

Remplacement de boitier externe du Samsung WB2100

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız bütün değişiklikler bu adımın yer aldığı diğer kılavuzları da etkileyecektir.

Sonraki adım

Adım 1 çevriliyor

Kılavuza Dön
İngilizce
Fransızca
Adım 1
Samsung WB2100 Back Cover Assembly Replacement: adım 0, 3 resimden 1. Samsung WB2100 Back Cover Assembly Replacement: adım 0, 3 resimden 2. Samsung WB2100 Back Cover Assembly Replacement: adım 0, 3 resimden 3.

  • Remove the 7 screws on the outside of the camera

  • Two 5 mm PH000 screws on the right side of the camera body

  • Four 3mm PH000 screws on the bottom and the left side of the camera body.

  • Use the plastic spudger to push the back casing out. Start from the right side and work your way clockwise around the case.

  • The HDMI / AV tab might fall out. this is supposed to happen as it is not screwed into place in the back casing.

Retirez les 7 vis à l'extérieur de la caméra

Deux vis PH000 de 5 mm sur le côté droit du boîtier de la caméra

Quatre vis PH000 de 3 mm en bas et sur le côté gauche du boîtier de la caméra.

Utilisez la spatule en plastique pour faire sortir le boîtier arrière. Commencez par le côté droit et travaillez dans le sens des aiguilles d'une montre autour du boîtier.

L'onglet HDMI / AV peut tomber. cela est censé se produire car il n'est pas vissé en place dans le boîtier arrière.

[* black] Remove the 7 screws on the outside of the camera
- [* red] Two 5 mm PH000 screws on the right side of the camera body
- [* orange] Four 3mm PH000 screws on the bottom and the left side of the camera body.
-[* black] Use the plastic spundger to push the back casing out. Start from the right side and work your way clockwise around the case.
+ [* orange] Two 5 mm PH000 screws on the right side of the camera body
+ [* yellow] Four 3mm PH000 screws on the bottom and the left side of the camera body.
+[* black] Use the plastic spudger to push the back casing out. Start from the right side and work your way clockwise around the case.
[* icon_note] The HDMI / AV tab might fall out. this is supposed to happen as it is not screwed into place in the back casing.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.