Ana içeriğe geç

为 Mac Mini 中期 2011 安装双硬盘组

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız bütün değişiklikler bu adımın yer aldığı diğer kılavuzları da etkileyecektir.

İngilizce
Çince

Adım 13 çevriliyor

Adım 13
Installing Mac mini Mid 2011 Dual Hard Drive Kit: adım 0, 2 resimden 1. Installing Mac mini Mid 2011 Dual Hard Drive Kit: adım 0, 2 resimden 2.
  • When you start up your machine, you'll see both drives are recognized by the mini.

  • Xbench scores show that if you install hard drives in either the top or the bottom position, their speeds will remain the same.

  • To minimize the amount of work necessary when adding an SSD to be used as your primary drive, we recommend installing the SSD like we did in this guide and leaving the stock platter drive in its original bottom position (closest to the antenna plate).

  • After reassembly, boot the mini into Lion Recovery and use disk utility to erase your SSD. Then install Lion on your SSD. After rebooting, go into system preferences>startup disk and choose your SSD as the startup disk.

您开电脑后,您可以看出Mini识别了两个硬盘。

Xbench分数显示,如果您将硬盘驱动器置于顶部或底部位置,则其速度将保持不变。

为了最大限度地减小主硬盘的SSD的工作量,我们建议像本指南中一样安装SSD,并将存储盘放在原始底部位置(最靠近天线板)。 重新组装后,将Mini引导至Lion Recovery,并使用磁盘实用程序擦除SSD。 然后在您的SSD上安装Lion。 重新启动后,进入系统首选项>启动磁盘,选择您的SSD作为启动盘。

-[* black] When you start up your machine, you'll see both drives are recognized by the Mini.
+[* black] When you start up your machine, you'll see both drives are recognized by the mini.
[* black] Xbench scores show that if you install hard drives in either the top or the bottom position, their speeds will remain the same.
-[* icon_note] To minimize the amount of work necessary when adding an SSD to be used as your primary drive, we recommend installing the SSD like we did in this guide and leaving the stock platter drive in its original bottom position (closest to the antenna plate). After reassembly, boot the Mini into [link|http://www.apple.com/macosx/recovery/|Lion Recovery] and use disk utility to erase your SSD. Then install Lion on your SSD. After rebooting, go into system preferences>startup disk and choose your SSD as the startup disk.
+[* icon_note] To minimize the amount of work necessary when adding an SSD to be used as your primary drive, we recommend installing the SSD like we did in this guide and leaving the stock platter drive in its original bottom position (closest to the antenna plate).
+ [* black] After reassembly, boot the mini into [link|http://www.apple.com/macosx/recovery/|Lion Recovery] and use disk utility to erase your SSD. Then install Lion on your SSD. After rebooting, go into system preferences>startup disk and choose your SSD as the startup disk.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.