replace blower motor resistor
how to replace blower motor resistor in 1999 dodge dakota
Görüntülenme:
Geçerli Oylar20 itibarın üzerindeki herkes sorunlu yorum ve gönderileri işaretleyebilir.
Detayları göster
İtibar: 1
Gönderildi:
how to replace blower motor resistor in 1999 dodge dakota
İtibar: 782,3b
Gönderildi:
wayne rients here is the way the manual describes it:
REMOVAL - BLOWER MOTOR RESISTOR
BLOWER MOTOR RESISTOR
(1) Disconnect and isolate the battery negative cable.
(2) From the passenger foot well area, remove the two hex screws used to secure the blower motor resistor.
(3) Unplug the front blower motor resistor from the wire harness connector.
(4) Pull the front blower motor resistor and its wire harness out of the plenum panel and through the cowl plenum access hole far enough to access the wire harness connector.
(5) Remove the front blower motor resistor from the cowl plenum.
INSTALLATION
(1) Plug the blower motor resistor into the wire harness connector.
(2) Install the blower motor resistor to the cowl plenum panel by feeding the resistor and wire harness back through the cowl plenum access hole.
(3) Install and tighten the two screws that secure the resistor to the HVAC unit. Tighten the screws to
2.2 N·m (20 in. lbs.).
(4) Connect the battery negative cable.
Here is that chapter from the manual Dakota HVAC Sometimes you may have to loosen the dash to get to it.
Ay! Fikrimi değiştirmek istiyorum.
Genişlet / Daralt
Başarılı
Yukarı
Başarısız
Aşağı
Yardım'ı Aç
Sayfa 1 / 1