İtibar: 1
2
This fell out during a screen replacement. It is not the rubber grommet that protects the ribbon cable from the motherboard. This is almost a cube in shape, solid rubber, had some adhesive on one face of it. Fell out when I was putting the logic board back in.
http://oi39.tinypic.com/5z3320.jpg
Anyone know what it is?
Bu iyi bir soru mu?
İtibar: 37,6b
22
51
42
It goes between the right hand side of the bottom speaker it's like a cushion and isn't needed
Bu yanıt yardımcı oldu mu?
İtibar: 576
11
4
2
While I an not completely sure what it is, I have seen it before around the camera, most likely there to provide spacing and a little bit of protection for it. If you are worried that not having that in your device would impact any performance or suitability, I wouldn't worry about it too much.
Ash
Bu yanıt yardımcı oldu mu?
Son 24 Saat: 0
Son 7 gün: 4
Son 30 gün: 5
Her zaman: 304
