Eşyalarını Tamir Et Topluluk Mağaza

Repair information, troubleshooting tips, and guides for the sixth iteration of Apple iPhone, announced on September 12, 2012. Model: A1428, A1429

2522 Soru Tümünü görüntüle

Seçenekler

shield screws mixed up

Hello

Hopefully you can help me

Change an iPhone 5 screen the other day but got the 3 shield screws mixed up. I've got the non magnetic one on underside of the motherboard but could only put a magnetic one on top . Also the other 2 are just random small screws .

How could this affect my phone

Also could I just purchase the 3 correct screws from you

I could buy a bag in eBay but if I got the whole set of screws I'd never know what 3 I needed

Can you help me please

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan -1
Yorum Ekle

3 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

The lower right one is the most important, if you use a screw that is too long you could strip the logic board grounding copper out and be left with a blue screen of death (BSOD) that renders the iPhone useless until repaired with microsoldering.

If you have a digital caliper I would recommend using that to measure the screws, correlate with the iFixit guide on the length and there's your fit.

iFixit doesn't sell the screws in question you need individually, except as a whole bag unit unfortunately. :-/

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1
Yorum Ekle

Seçenekler

Thanks for that

What's the length of those 2 at the bottom. I can at least make sure they are the right length

Thanks

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0

1 Yorum:

According to our guide it is 1.2mm. Fortunately both bottom screws are the same, so as long as you have the upper right correct you're in the clear!

iPhone 5 Ekran Düzeneği Değişimi

tarafından

Yorum Ekle

Seçenekler

non magnetic is always top right. i would love to know why this is. somebody please tell me, it has been killing me for ages.

whenever you're in doubt just look at what it's screwing into. If that screw is going into a standoff then you're going to want the long screw, if it's going into the logic board then you want the short screw.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0

2 Yorum:

That's because the compass module (chip/fuse/whatever?) is housed there. Magnetic would throw it off :P

tarafından

I finally have an answer... everytime I remove that screw I ask myself this question. Thank you!

tarafından

Yorum Ekle

Yanıtını ekle

lee ball sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 1

Her zaman: 1,552