Model A1046 or A1095 / 1280x854 screen resolution

163 Soru Tümünü görüntüle

Replaced hard drive, but still freezes and trouble starting?

PowerBook G4 Aluminum 15" 1.25Ghz A1046

So I have replaced my hard drive, possibly unnecessarily, and have gotten it to boot up until I am choosing language options from the tiger startup screen. It continues to freeze and when I shut it down to start again it will not even start. I have tried the PMU but still doesn't start. Any advice?

Yanıtlandı! View the answer Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 0

Yorumlar:

Are you using the original installation disk?

tarafından

Yorum Ekle
Spread Fixmas Cheer
Get $12 off your purchase of $50 or more with code FIXMAS12
Spread Fixmas Cheer
Get $12 off your purchase of $50 or more with code FIXMAS12

1 Cevap

Filtre ölçütü:
Seçilen Çözüm

With it not restarting, it sounds like a heat issues. Open it up and clean the fans. For a better result, open it and remove the logic board and clean out the heat sink vent ports and replace the thermal paste. Warning: this is a difficult procedure and you really have to pay attention to get all the cable out from under the board when replacing it. I did one last week and had to take the logic board out twice due to a heat sensor cable getting under the board. I also take pictures as I go to augment the guides. Also ESD protocols must be followed.

Here's how to remove the board: PowerBook G4 Aluminum 15" 1-1.5 GHz Logic Board Replacement

Here's the guide on replacing thermal paste: How to Apply Thermal Paste

PowerBook G4 Aluminum 15" 1-1.5 GHz Logic Board Resmi

Kılavuz

PowerBook G4 Aluminum 15" 1-1.5 GHz Logic Board Replacement

Zorluk:

Zor

Electronics Skills Resmi

Kılavuz

How to Apply Thermal Paste

Zorluk:

Kolay

5 - 20 minutes

Bu yanıt yardımcı oldu mu?

Puan 2

Yorumlar:

good answer +

tarafından

Yorum Ekle

Yanıtını ekle

Steve Lynn sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 972